A selective and simple method has been developed for preconcentration of Ni on C18 disks nano graphene with aminopropyltriethoxysilane (APTES). Simple chemical bonding method to synthesize nano graphene with aminopropyltriethoxysilane (APTES) was reported. The adsorption behaviors of Ni (II) in aqueous solution on APTES were systematically investigated. The procedure is based on the selective formation of Ni (II) at optimum pH by elution with organic effluents and determination by flame atomic absorption spectrometry. The method is based on complex formation on the surface of the ENVI-18 DISKTM disks nano graphene with amino propyltriethoxysilane (APTES) followed by stripping of the retained species by minimum amounts of appropriate organic solvents. The elution is efficient and quantitative. The effect of potential interfering ions, pH, APTES amount, stripping solvent, and sample flow rate were also investigated. Under the optimal experimental conditions, the break-through volume was found to about 1000mL providing a preconcentration factor of 600. The maximum capacity of the disk nano graphene with aminopropyltriethoxysilane (APTES) was found to be 398± 3 µg for Ni2+. The limit of detection of the proposed method is 5mg per 1000mL.The method was applied to the extraction and recovery of Ni in different water samples.